Diagnostics

Welcome to FAQ

Engine

How can I set idle speed ?

Video Idle speed adjustment.

Can I program VIN ?

This function is preparing.

VCI not connected to vehicle.

Check you are connected in the right diagnostic connector (Data link) ?

Diag4bike VCI not responding

Check connection between VCI and PC (USB cable or Bluetooth work properly).

I can´t get information from ECU Thundermax 6 pin.

ECU Thundermax does not support this function.

I set idle speed to 900 RPM but it runs higher.

Idle speed can be setted in the range 800-1250 RPM at engine operating temperature.

If engine runs at other than setted idle speed, it is done by fuel maps and it can be changed with Diag4Tune software.

ABS

I can´t perform ABS bleeding on FLHR 2005 .

For this motorcycle is not supported ABS bleeding . This motorcycle has for ABS special connector.

Can I turn off ABS telltale?

ABS telltale can be turn off only on CAN (6 pin) motorcycles.

Funcion is in Toolbox.

How perform ABS bleeding ?

Video manual.

ABS bleeding procedure was not successful

You must battery connect on the battery charger.

Security module

How can I disarm TSSM ?

You can do it by PIN number or assigned Key FOB, link to manual .

How to customize TSSM ?

Link to manual.

Motorcycle is turn off after pairing

Control unit isn´t jointed with TSSM, HFSM, BCM.

Pairing not successful correctly.

Toolbox

Can I do Module replacement with blank ECU ?

ECU must be SW from Harley Davidson®. Use the Diag4Bike for function flash ECM. Manual ECM Flash.

How to configure lights ?

Below functions are placed in the Toolbox BCM customization.

Turn Signal/Stop Lamp -> Dedicated brake lamp, Turn signal lamps, Run Lighting in Accessory ->ON, OFF, Headlamp -> Standard, Dual Halogen, Auxiliary/Fog Light Operation egacy, P and A, Touring

How to change Km to Mil.

This is in the Diagnostics (toolbox). Video manual

How to disable jiffy stand sensor ?

This function is in the toolbox.

Turn lights setting from American to European.

This is supported only for CAN models.

I can´t perform disarming.

Check all conditions in the manual.

How to disable exhaust flap ?

Video manual

How to do Speedometer pairing ?

This function is in the Diagnostics -> Toolbox

Speedometer calibration after change the front wheel ?