CONFIGURATION OF THE DIAG4BIKE PROGRAM
For correct function of the DIAG4BIKE program, the VCI (Vehicle communication interface) communication interface must be configured correctly.
Has the configuration not been carried out, or has it been prematurely terminated in the past, each time the program DIAG4BIKE is run, the operator is notified correspondingly.
| 1/ Settings of the communication with PC, recommended to use the „Reset“ button | 7/ Select Printer | ||
| 2/ Serial number input, recommended to use the „Reset“ button | 8/ Company name | ||
| 3/ Firmware update, recommended to use the „Reset“ button | 9/ Insert user’s logo | ||
| 4/ The „Reset“ button performs the function of searching for changes in VCI configuration, and of completing all necessary data | 10/ Analog measurement | ||
| 5/ Language selection | 11/ Measures and units | ||
| 6/ Screen resolution selection | 12/ Confirmation of changes and closing of the configuration window |
AUTOMATIC CONFIGURATION WITH „VCI CONFIGURATION ASSISTANT“
If you configure the program in a computer with Windows 7, 8.1, 10 operating system, you must have administrator rights.
This program is run automatically in two cases:
a) If the configuration of the VCI device WAS NOT carried out (mostly after the first installation of the program).
b) In case that the „VCI Configuration Assistant“ detects any problems with the configuration, e.g. incompliance of the series number, obsolete firmware version, etc. In this case it is recommended to click on the „Reset“ button, and everything gets updated automatically.
VCI MANUAL CONFIGURATION
The configuration program is started by clicking on „DIAG4BIKE Configuration
STARTING THE „VCI CONFIGURATION ASSISTANT“
After the „VCI configuration assistant“ program is started, revision of all accessible information is carried out.
In case that information are not accessible or VCI is not connected to the computer, an information window is displayed with a request to connect the VCI communication interface to the computer.
After the „NEXT“ button is pressed, checking and configuration of the VCI, eventually search for a requested device is started. If the VCI is not found or a problem occurs, e.g. loss of communication or power failure, an information window is displayed. After the fault is eliminated, configuration will continue automatically.
INTERRUPTION OF THE „VCI CONFIGURATION ASSISTANT“
In case that the VCI configuration is ended prematurely, e.g. by turning off the computer, the operator is notified at its restart that the original configuration was not completed. Vehicle diagnostics shall not be allowed until the VCI configuration is orderly completed.
RESET „VCI CONFIGURATION ASSISTANT“
In case of a request for a new configuration, e.g. after replacement of VCI, verification of firmware update status, etc., the „Reset“ button is to be utilized which performs the function of searching for changes in VCI configuration, and of completing all necessary dat
